#define MESH_FLAGS_AE 0x3
#define MESH_FLAGS_PS_DEEP 0x4
+/**
+ * enum ieee80211_preq_flags - mesh PREQ element flags
+ *
+ * @IEEE80211_PREQ_PROACTIVE_PREP_FLAG: proactive PREP subfield
+ */
+enum ieee80211_preq_flags {
+ IEEE80211_PREQ_PROACTIVE_PREP_FLAG = 1<<2,
+};
+
+/**
+ * enum ieee80211_preq_target_flags - mesh PREQ element per target flags
+ *
+ * @IEEE80211_PREQ_TO_FLAG: target only subfield
+ * @IEEE80211_PREQ_USN_FLAG: unknown target HWMP sequence number subfield
+ */
+enum ieee80211_preq_target_flags {
+ IEEE80211_PREQ_TO_FLAG = 1<<0,
+ IEEE80211_PREQ_USN_FLAG = 1<<2,
+};
+
/**
* struct ieee80211_quiet_ie
*
u8 rann_hopcount;
u8 rann_ttl;
u8 rann_addr[6];
- u32 rann_seq;
- u32 rann_interval;
- u32 rann_metric;
+ __le32 rann_seq;
+ __le32 rann_interval;
+ __le32 rann_metric;
} __attribute__ ((packed));
enum ieee80211_rann_flags {
};
/**
- * struct ieee80211_ht_info - HT information
+ * struct ieee80211_ht_operation - HT operation IE
*
- * This structure is the "HT information element" as
- * described in 802.11n D5.0 7.3.2.58
+ * This structure is the "HT operation element" as
+ * described in 802.11n-2009 7.3.2.57
*/
-struct ieee80211_ht_info {
- u8 control_chan;
+struct ieee80211_ht_operation {
+ u8 primary_chan;
u8 ht_param;
__le16 operation_mode;
__le16 stbc_param;
#define IEEE80211_HT_PARAM_CHA_SEC_BELOW 0x03
#define IEEE80211_HT_PARAM_CHAN_WIDTH_ANY 0x04
#define IEEE80211_HT_PARAM_RIFS_MODE 0x08
-#define IEEE80211_HT_PARAM_SPSMP_SUPPORT 0x10
-#define IEEE80211_HT_PARAM_SERV_INTERVAL_GRAN 0xE0
/* for operation_mode */
#define IEEE80211_HT_OP_MODE_PROTECTION 0x0003
#define WLAN_HT_SMPS_CONTROL_STATIC 1
#define WLAN_HT_SMPS_CONTROL_DYNAMIC 3
+#define VHT_MCS_SUPPORTED_SET_SIZE 8
+
+struct ieee80211_vht_capabilities {
+ __le32 vht_capabilities_info;
+ u8 vht_supported_mcs_set[VHT_MCS_SUPPORTED_SET_SIZE];
+} __packed;
+
+struct ieee80211_vht_operation {
+ u8 vht_op_info_chwidth;
+ u8 vht_op_info_chan_center_freq_seg1_idx;
+ u8 vht_op_info_chan_center_freq_seg2_idx;
+ __le16 vht_basic_mcs_set;
+} __packed;
+
+/**
+ * struct ieee80211_vht_mcs_info - VHT MCS information
+ * @rx_mcs_map: RX MCS map 2 bits for each stream, total 8 streams
+ * @rx_highest: Indicates highest long GI VHT PPDU data rate
+ * STA can receive. Rate expressed in units of 1 Mbps.
+ * If this field is 0 this value should not be used to
+ * consider the highest RX data rate supported.
+ * @tx_mcs_map: TX MCS map 2 bits for each stream, total 8 streams
+ * @tx_highest: Indicates highest long GI VHT PPDU data rate
+ * STA can transmit. Rate expressed in units of 1 Mbps.
+ * If this field is 0 this value should not be used to
+ * consider the highest TX data rate supported.
+ */
+struct ieee80211_vht_mcs_info {
+ __le16 rx_mcs_map;
+ __le16 rx_highest;
+ __le16 tx_mcs_map;
+ __le16 tx_highest;
+} __packed;
+
+#define IEEE80211_VHT_MCS_ZERO_TO_SEVEN_SUPPORT 0
+#define IEEE80211_VHT_MCS_ZERO_TO_EIGHT_SUPPORT 1
+#define IEEE80211_VHT_MCS_ZERO_TO_NINE_SUPPORT 2
+#define IEEE80211_VHT_MCS_NOT_SUPPORTED 3
+
+/* 802.11ac VHT Capabilities */
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_3895 0x00000000
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_7991 0x00000001
+#define IEEE80211_VHT_CAP_MAX_MPDU_LENGTH_11454 0x00000002
+#define IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160MHZ 0x00000004
+#define IEEE80211_VHT_CAP_SUPP_CHAN_WIDTH_160_80PLUS80MHZ 0x00000008
+#define IEEE80211_VHT_CAP_RXLDPC 0x00000010
+#define IEEE80211_VHT_CAP_SHORT_GI_80 0x00000020
+#define IEEE80211_VHT_CAP_SHORT_GI_160 0x00000040
+#define IEEE80211_VHT_CAP_TXSTBC 0x00000080
+#define IEEE80211_VHT_CAP_RXSTBC_1 0x00000100
+#define IEEE80211_VHT_CAP_RXSTBC_2 0x00000200
+#define IEEE80211_VHT_CAP_RXSTBC_3 0x00000300
+#define IEEE80211_VHT_CAP_RXSTBC_4 0x00000400
+#define IEEE80211_VHT_CAP_SU_BEAMFORMER_CAPABLE 0x00000800
+#define IEEE80211_VHT_CAP_SU_BEAMFORMEE_CAPABLE 0x00001000
+#define IEEE80211_VHT_CAP_BEAMFORMER_ANTENNAS_MAX 0x00006000
+#define IEEE80211_VHT_CAP_SOUNDING_DIMENTION_MAX 0x00030000
+#define IEEE80211_VHT_CAP_MU_BEAMFORMER_CAPABLE 0x00080000
+#define IEEE80211_VHT_CAP_MU_BEAMFORMEE_CAPABLE 0x00100000
+#define IEEE80211_VHT_CAP_VHT_TXOP_PS 0x00200000
+#define IEEE80211_VHT_CAP_HTC_VHT 0x00400000
+#define IEEE80211_VHT_CAP_MAX_A_MPDU_LENGTH_EXPONENT 0x00800000
+#define IEEE80211_VHT_CAP_VHT_LINK_ADAPTATION_VHT_UNSOL_MFB 0x08000000
+#define IEEE80211_VHT_CAP_VHT_LINK_ADAPTATION_VHT_MRQ_MFB 0x0c000000
+#define IEEE80211_VHT_CAP_RX_ANTENNA_PATTERN 0x10000000
+#define IEEE80211_VHT_CAP_TX_ANTENNA_PATTERN 0x20000000
+
/* Authentication algorithms */
#define WLAN_AUTH_OPEN 0
#define WLAN_AUTH_SHARED_KEY 1
WLAN_EID_EXT_SUPP_RATES = 50,
WLAN_EID_HT_CAPABILITY = 45,
- WLAN_EID_HT_INFORMATION = 61,
+ WLAN_EID_HT_OPERATION = 61,
WLAN_EID_RSN = 48,
WLAN_EID_MMIE = 76,
WLAN_EID_DSE_REGISTERED_LOCATION = 58,
WLAN_EID_SUPPORTED_REGULATORY_CLASSES = 59,
WLAN_EID_EXT_CHANSWITCH_ANN = 60,
+
+ WLAN_EID_VHT_CAPABILITY = 191,
+ WLAN_EID_VHT_OPERATION = 192,
};
/* Action category code */
/* TDLS specific payload type in the LLC/SNAP header */
#define WLAN_TDLS_SNAP_RFTYPE 0x2
+/**
+ * enum - mesh synchronization method identifier
+ *
+ * @IEEE80211_SYNC_METHOD_NEIGHBOR_OFFSET: the default synchronization method
+ * @IEEE80211_SYNC_METHOD_VENDOR: a vendor specific synchronization method
+ * that will be specified in a vendor specific information element
+ */
+enum {
+ IEEE80211_SYNC_METHOD_NEIGHBOR_OFFSET = 1,
+ IEEE80211_SYNC_METHOD_VENDOR = 255,
+};
+
/**
* enum - mesh path selection protocol identifier
*
* @IEEE80211_PATH_PROTOCOL_HWMP: the default path selection protocol
* @IEEE80211_PATH_PROTOCOL_VENDOR: a vendor specific protocol that will
- * be specified in a vendor specific information element
+ * be specified in a vendor specific information element
*/
enum {
- IEEE80211_PATH_PROTOCOL_HWMP = 0,
+ IEEE80211_PATH_PROTOCOL_HWMP = 1,
IEEE80211_PATH_PROTOCOL_VENDOR = 255,
};
*
* @IEEE80211_PATH_METRIC_AIRTIME: the default path selection metric
* @IEEE80211_PATH_METRIC_VENDOR: a vendor specific metric that will be
- * specified in a vendor specific information element
+ * specified in a vendor specific information element
*/
enum {
- IEEE80211_PATH_METRIC_AIRTIME = 0,
+ IEEE80211_PATH_METRIC_AIRTIME = 1,
IEEE80211_PATH_METRIC_VENDOR = 255,
};
+/**
+ * enum ieee80211_root_mode_identifier - root mesh STA mode identifier
+ *
+ * These attribute are used by dot11MeshHWMPRootMode to set root mesh STA mode
+ *
+ * @IEEE80211_ROOTMODE_NO_ROOT: the mesh STA is not a root mesh STA (default)
+ * @IEEE80211_ROOTMODE_ROOT: the mesh STA is a root mesh STA if greater than
+ * this value
+ * @IEEE80211_PROACTIVE_PREQ_NO_PREP: the mesh STA is a root mesh STA supports
+ * the proactive PREQ with proactive PREP subfield set to 0
+ * @IEEE80211_PROACTIVE_PREQ_WITH_PREP: the mesh STA is a root mesh STA
+ * supports the proactive PREQ with proactive PREP subfield set to 1
+ * @IEEE80211_PROACTIVE_RANN: the mesh STA is a root mesh STA supports
+ * the proactive RANN
+ */
+enum ieee80211_root_mode_identifier {
+ IEEE80211_ROOTMODE_NO_ROOT = 0,
+ IEEE80211_ROOTMODE_ROOT = 1,
+ IEEE80211_PROACTIVE_PREQ_NO_PREP = 2,
+ IEEE80211_PROACTIVE_PREQ_WITH_PREP = 3,
+ IEEE80211_PROACTIVE_RANN = 4,
+};
/*
* IEEE 802.11-2007 7.3.2.9 Country information element
#define WLAN_OUI_WFA 0x506f9a
#define WLAN_OUI_TYPE_WFA_P2P 9
+#define WLAN_OUI_MICROSOFT 0x0050f2
+#define WLAN_OUI_TYPE_MICROSOFT_WPA 1
+#define WLAN_OUI_TYPE_MICROSOFT_WMM 2
+#define WLAN_OUI_TYPE_MICROSOFT_WPS 4
/*
* WMM/802.11e Tspec Element