carl9170 firmware: set NO ACK bit in BA control
[carl9170fw.git] / carlfw / src / wlan.c
index a7c805b588908267541bd994f6c878a0abea16c2..c23831bd358ffad0f2a4d5453e4f838dbb85004f 100644 (file)
@@ -292,25 +292,12 @@ static void __wlan_tx(struct dma_desc *desc)
 
        wlan_tx_ampdu(super);
 
-#if (defined CONFIG_CARL9170FW_LOOPBACK) || (defined CONFIG_CARL9170FW_DISCARD)
-       wlan_tx_complete(super, true);
-       unhide_super(desc);
-# ifdef CONFIG_CARL9170FW_LOOPBACK
-       dma_put(&fw.pta.up_queue, desc);
-       up_trigger();
-# elif CONFIG_CARL9170FW_DISCARD
-       dma_reclaim(&fw.pta.down_queue, desc);
-       down_trigger();
-# endif
-#else /* CONFIG_CARL9170FW_LOOPBACK */
-
-# ifdef CONFIG_CARL9170FW_DEBUG
+#ifdef CONFIG_CARL9170FW_DEBUG
        BUG_ON(fw.phy.psm.state != CARL9170_PSM_WAKE);
-# endif /* CONFIG_CARL9170FW_DEBUG */
+#endif /* CONFIG_CARL9170FW_DEBUG */
 
        /* insert desc into the right queue */
        dma_put(&fw.wlan.tx_queue[super->s.queue], desc);
-#endif /* CONFIG_CARL9170FW_LOOPBACK */
 }
 
 static void wlan_assign_seq(struct ieee80211_hdr *hdr, unsigned int vif)
@@ -318,7 +305,7 @@ static void wlan_assign_seq(struct ieee80211_hdr *hdr, unsigned int vif)
        hdr->seq_ctrl &= cpu_to_le16(~IEEE80211_SCTL_SEQ);
        hdr->seq_ctrl |= cpu_to_le16(fw.wlan.sequence[vif]);
 
-       if (!(hdr->seq_ctrl & cpu_to_le16(IEEE80211_SCTL_FRAG)))
+       if (ieee80211_is_first_frag(hdr->seq_ctrl))
                fw.wlan.sequence[vif] += 0x10;
 }
 
@@ -358,12 +345,28 @@ static bool wlan_tx_status(struct dma_queue *queue,
        /* update hangcheck */
        fw.wlan.last_super_num[qidx] = 0;
 
+       /*
+        * Note:
+        * There could be a corner case when the TXFAIL is set
+        * even though the frame was properly ACKed by the peer:
+        *   a BlockAckReq with the immediate policy will cause
+        *   the receiving peer to produce a BlockACK unfortunately
+        *   the MAC in this chip seems to be expecting a legacy
+        *   ACK and marks the BAR as failed!
+        */
+
        if (!!(desc->ctrl & AR9170_CTRL_FAIL)) {
                txfail = !!(desc->ctrl & AR9170_CTRL_TXFAIL);
 
                /* reset retry indicator flags */
                desc->ctrl &= ~(AR9170_CTRL_TXFAIL | AR9170_CTRL_BAFAIL);
 
+               /*
+                * Note: wlan_tx_consume_retry will override the old
+                * phy [CCK,OFDM, HT, BW20/40, MCS...] and mac vectors
+                * [AMPDU,RTS/CTS,...] therefore be careful when they
+                * are used.
+                */
                if (wlan_tx_consume_retry(super)) {
                        /*
                         * retry for simple and aggregated 802.11 frames.
@@ -533,7 +536,7 @@ static void wlan_send_buffered_ba(void)
        struct ieee80211_ba *ba = (struct ieee80211_ba *) &baf->f.ba;
        struct carl9170_bar_ctx *ctx;
 
-       if (likely(fw.wlan.ba_head_idx == fw.wlan.ba_tail_idx))
+       if (likely(!fw.wlan.queued_ba))
                return;
 
        /* there's no point to continue when the ba_desc is not available. */
@@ -543,6 +546,7 @@ static void wlan_send_buffered_ba(void)
        ctx = &fw.wlan.ba_cache[fw.wlan.ba_head_idx];
        fw.wlan.ba_head_idx++;
        fw.wlan.ba_head_idx %= CONFIG_CARL9170FW_BACK_REQS_NUM;
+       fw.wlan.queued_ba--;
 
        baf->s.len = sizeof(struct carl9170_tx_superdesc) +
                     sizeof(struct ar9170_tx_hwdesc) +
@@ -552,19 +556,20 @@ static void wlan_send_buffered_ba(void)
        baf->s.queue = AR9170_TXQ_VO;
        baf->f.hdr.length = sizeof(struct ieee80211_ba) + FCS_LEN;
 
-       /* HW Duration / Backoff */
-       baf->f.hdr.mac.backoff = 1;
-       baf->f.hdr.mac.hw_duration = 1;
+       baf->f.hdr.mac.no_ack = 1;
 
-       /* take the TX rate from the RX'd BAR */
-       baf->f.hdr.phy.set = ctx->phy;
-       baf->f.hdr.phy.tx_power = 29; /* 14.5 dBm */
+       baf->f.hdr.phy.modulation = 1; /* OFDM */
+       baf->f.hdr.phy.tx_power = 34; /* 17 dBm */
+       baf->f.hdr.phy.chains = 1;
+       baf->f.hdr.phy.mcs = AR9170_TXRX_PHY_RATE_OFDM_6M;
 
        /* format outgoing BA */
-       ba->frame_control = cpu_to_le16(IEEE80211_FTYPE_CTL | IEEE80211_STYPE_NULLFUNC);
+       ba->frame_control = cpu_to_le16(IEEE80211_FTYPE_CTL | IEEE80211_STYPE_BACK);
        ba->duration = cpu_to_le16(0);
-       memcpy(ba->ta, ctx->ta, 6);
-       memcpy(ba->ra, ctx->ra, 6);
+
+       /* the BAR contains all necessary MACs. All we need is to swap them */
+       memcpy(ba->ra, ctx->ta, 6);
+       memcpy(ba->ta, ctx->ra, 6);
 
        /*
         * Unfortunately, we cannot look into the hardware's scoreboard.
@@ -574,8 +579,8 @@ static void wlan_send_buffered_ba(void)
        memset(ba->bitmap, 0x0, sizeof(ba->bitmap));
 
        /*
-        * NB:
-        * not entirely sure if this is 100% correct?!
+        * Both, the original firmare and ath9k set the NO ACK flag in
+        * the BA Ack Policy subfield.
         */
        ba->control = ctx->control | cpu_to_le16(1);
        ba->start_seq_num = ctx->start_seq_num;
@@ -589,11 +594,13 @@ static struct carl9170_bar_ctx *wlan_get_bar_cache_buffer(void)
        tmp = &fw.wlan.ba_cache[fw.wlan.ba_tail_idx];
        fw.wlan.ba_tail_idx++;
        fw.wlan.ba_tail_idx %= CONFIG_CARL9170FW_BACK_REQS_NUM;
+       if (fw.wlan.queued_ba < CONFIG_CARL9170FW_BACK_REQS_NUM)
+               fw.wlan.queued_ba++;
 
        return tmp;
 }
 
-static void handle_bar(struct dma_desc *desc, struct ieee80211_hdr *hdr,
+static void handle_bar(struct dma_desc *desc __unused, struct ieee80211_hdr *hdr,
                       unsigned int len, unsigned int mac_err)
 {
        struct ieee80211_bar *bar;
@@ -627,22 +634,10 @@ static void handle_bar(struct dma_desc *desc, struct ieee80211_hdr *hdr,
 
        ctx = wlan_get_bar_cache_buffer();
 
-       /* Brilliant! The BAR provides all necessary MACs! */
-       memcpy(ctx->ra, bar->ta, 6);
-       memcpy(ctx->ta, bar->ra, 6);
-
-       /*
-        * NB:
-        * not entirely sure if this is 100% correct to force the
-        * imm ack bit or not...
-        */
-       ctx->control = bar->control | cpu_to_le16(1);
+       memcpy(ctx->ra, bar->ra, 6);
+       memcpy(ctx->ta, bar->ta, 6);
+       ctx->control = bar->control;
        ctx->start_seq_num = bar->start_seq_num;
-       ctx->phy = ar9170_rx_to_phy(desc);
-       if (unlikely(!ctx->phy)) {
-               /* provide a backup, in case ar9170_rx_to_phy fails */
-               ctx->phy = cpu_to_le32(0x2cc301);
-       }
 }
 
 static void wlan_check_rx_overrun(void)