2 # PHY Layer Configuration
6 tristate "MDIO bus device drivers"
8 MDIO devices and driver infrastructure code.
15 This internal symbol is used for link time dependencies and it
16 reflects whether the mdio_bus/mdio_device code is built as a
17 loadable module or built-in.
22 tristate "Broadcom iProc MDIO bus controller"
23 depends on ARCH_BCM_IPROC || COMPILE_TEST
24 depends on HAS_IOMEM && OF_MDIO
26 This module provides a driver for the MDIO busses found in the
29 config MDIO_BCM_UNIMAC
30 tristate "Broadcom UniMAC MDIO bus controller"
31 depends on HAS_IOMEM && OF_MDIO
33 This module provides a driver for the Broadcom UniMAC MDIO busses.
34 This hardware can be found in the Broadcom GENET Ethernet MAC
35 controllers as well as some Broadcom Ethernet switches such as the
36 Starfighter 2 switches.
39 tristate "Bitbanged MDIO buses"
41 This module implements the MDIO bus protocol in software,
42 for use by low level drivers that export the ability to
43 drive the relevant pins.
51 This module provides a driver framework for MDIO bus
52 multiplexers which connect one of several child MDIO busses
53 to a parent bus. Switching between child busses is done by
54 device specific drivers.
56 config MDIO_BUS_MUX_BCM_IPROC
57 tristate "Broadcom iProc based MDIO bus multiplexers"
58 depends on OF && OF_MDIO && (ARCH_BCM_IPROC || COMPILE_TEST)
60 default ARCH_BCM_IPROC
62 This module provides a driver for MDIO bus multiplexers found in
63 iProc based Broadcom SoCs. This multiplexer connects one of several
64 child MDIO bus to a parent bus. Buses could be internal as well as
65 external and selection logic lies inside the same multiplexer.
67 config MDIO_BUS_MUX_GPIO
68 tristate "GPIO controlled MDIO bus multiplexers"
69 depends on OF_GPIO && OF_MDIO
72 This module provides a driver for MDIO bus multiplexers that
73 are controlled via GPIO lines. The multiplexer connects one of
74 several child MDIO busses to a parent bus. Child bus
75 selection is under the control of GPIO lines.
77 config MDIO_BUS_MUX_MMIOREG
78 tristate "MMIO device-controlled MDIO bus multiplexers"
79 depends on OF_MDIO && HAS_IOMEM
82 This module provides a driver for MDIO bus multiplexers that
83 are controlled via a simple memory-mapped device, like an FPGA.
84 The multiplexer connects one of several child MDIO busses to a
85 parent bus. Child bus selection is under the control of one of
88 Currently, only 8/16/32 bits registers are supported.
94 tristate "GPIO lib-based bitbanged MDIO buses"
95 depends on MDIO_BITBANG && GPIOLIB
97 Supports GPIO lib-based MDIO busses.
99 To compile this driver as a module, choose M here: the module
100 will be called mdio-gpio.
102 config MDIO_HISI_FEMAC
103 tristate "Hisilicon FEMAC MDIO bus controller"
104 depends on HAS_IOMEM && OF_MDIO
106 This module provides a driver for the MDIO busses found in the
107 Hisilicon SoC that have an Fast Ethernet MAC.
113 Support I2C based PHYs. This provides a MDIO bus bridged
114 to I2C to allow PHYs connected in I2C mode to be accessed
115 using the existing infrastructure.
117 This is library mode.
120 tristate "MOXA ART MDIO interface support"
121 depends on ARCH_MOXART
123 This driver supports the MDIO interface found in the network
124 interface units of the MOXA ART SoC
127 tristate "Octeon and some ThunderX SOCs MDIO buses"
129 depends on HAS_IOMEM && OF_MDIO
132 This module provides a driver for the Octeon and ThunderX MDIO
133 buses. It is required by the Octeon and ThunderX ethernet device
134 drivers on some systems.
137 tristate "Allwinner sun4i MDIO interface support"
138 depends on ARCH_SUNXI
140 This driver supports the MDIO interface found in the network
141 interface units of the Allwinner SoC that have an EMAC (A10,
145 tristate "ThunderX SOCs MDIO buses"
151 This driver supports the MDIO interfaces found on Cavium
152 ThunderX SoCs when the MDIO bus device appears as a PCI
156 tristate "APM X-Gene SoC MDIO bus controller"
157 depends on ARCH_XGENE || COMPILE_TEST
159 This module provides a driver for the MDIO busses found in the
166 depends on NETDEVICES
170 PHYlink models the link between the PHY and MAC, allowing fixed
171 configuration links, PHYs, and Serdes links with MAC level
172 autonegotiation modes.
175 tristate "PHY Device support and infrastructure"
176 depends on NETDEVICES
179 Ethernet controllers are usually attached to PHY
180 devices. This option provides infrastructure for
181 managing PHY devices.
188 config LED_TRIGGER_PHY
189 bool "Support LED triggers for tracking link state"
190 depends on LEDS_TRIGGERS
192 Adds support for a set of LED trigger events per-PHY. Link
193 state change will trigger the events, for consumption by an
194 LED class driver. There are triggers for each link speed currently
195 supported by the phy, and are of the form:
196 <mii bus id>:<phy>:<speed>
198 Where speed is in the form:
199 <Speed in megabits>Mbps or <Speed in gigabits>Gbps
202 comment "MII PHY device drivers"
205 tristate "SFP cage support"
206 depends on I2C && PHYLINK
212 Currently supports the am79c874
215 tristate "Aquantia PHYs"
217 Currently supports the Aquantia AQ1202, AQ2104, AQR105, AQR405
220 tristate "AT803X PHYs"
222 Currently supports the AT8030 and AT8035 model
225 tristate "Broadcom 63xx SOCs internal PHY"
227 select BCM_NET_PHYLIB
229 Currently supports the 6348 and 6358 PHYs.
232 tristate "Broadcom 7xxx SOCs internal PHYs"
233 select BCM_NET_PHYLIB
235 Currently supports the BCM7366, BCM7439, BCM7445, and
236 40nm and 65nm generation of BCM7xxx Set Top Box SoCs.
239 tristate "Broadcom BCM8706 and BCM8727 PHYs"
241 Currently supports the BCM8706 and BCM8727 10G Ethernet PHYs.
243 config BCM_CYGNUS_PHY
244 tristate "Broadcom Cygnus SoC internal PHY"
245 depends on ARCH_BCM_CYGNUS || COMPILE_TEST
246 depends on MDIO_BCM_IPROC
247 select BCM_NET_PHYLIB
249 This PHY driver is for the 1G internal PHYs of the Broadcom
252 Currently supports internal PHY's used in the BCM11300,
253 BCM11320, BCM11350, BCM11360, BCM58300, BCM58302,
254 BCM58303 & BCM58305 Broadcom Cygnus SoCs.
256 config BCM_NET_PHYLIB
260 tristate "Broadcom PHYs"
261 select BCM_NET_PHYLIB
263 Currently supports the BCM5411, BCM5421, BCM5461, BCM54616S, BCM5464,
264 BCM5481, BCM54810 and BCM5482 PHYs.
267 tristate "Cicada PHYs"
269 Currently supports the cis8204
272 tristate "Cortina EDC CDR 10G Ethernet PHY"
274 Currently supports the CS4340 phy.
277 tristate "Davicom PHYs"
279 Currently supports dm9161e and dm9131
282 tristate "Texas Instruments DP83848 PHY"
284 Supports the DP83848 PHY.
287 tristate "Texas Instruments DP83867 Gigabit PHY"
289 Currently supports the DP83867 PHY.
292 tristate "MDIO Bus/PHY emulation with fixed speed/link PHYs"
296 Adds the platform "fixed" MDIO Bus to cover the boards that use
297 PHYs that are not connected to the real MDIO bus.
299 Currently tested with mpc866ads and mpc8349e-mitx.
302 tristate "ICPlus PHYs"
304 Currently supports the IP175C and IP1001 PHYs.
306 config INTEL_XWAY_PHY
307 tristate "Intel XWAY PHYs"
309 Supports the Intel XWAY (former Lantiq) 11G and 22E PHYs.
310 These PHYs are marked as standalone chips under the names
311 PEF 7061, PEF 7071 and PEF 7072 or integrated into the Intel
312 SoCs xRX200, xRX300, xRX330, xRX350 and xRX550.
314 config LSI_ET1011C_PHY
315 tristate "LSI ET1011C PHY"
317 Supports the LSI ET1011C PHY.
320 tristate "Intel LXT PHYs"
322 Currently supports the lxt970, lxt971
325 tristate "Marvell PHYs"
327 Currently has a driver for the 88E1011S
329 config MARVELL_10G_PHY
330 tristate "Marvell Alaska 10Gbit PHYs"
332 Support for the Marvell Alaska MV88X3310 and compatible PHYs.
335 tristate "Amlogic Meson GXL Internal PHY"
336 depends on ARCH_MESON || COMPILE_TEST
338 Currently has a driver for the Amlogic Meson GXL Internal PHY
341 tristate "Micrel PHYs"
343 Supports the KSZ9021, VSC8201, KS8001 PHYs.
346 tristate "Microchip PHYs"
348 Supports the LAN88XX PHYs.
351 tristate "Microsemi PHYs"
353 Currently supports VSC8530, VSC8531, VSC8540 and VSC8541 PHYs
356 tristate "National Semiconductor PHYs"
358 Currently supports the DP83865 PHY.
361 tristate "Quality Semiconductor PHYs"
363 Currently supports the qs6612
366 tristate "Realtek PHYs"
368 Supports the Realtek 821x PHY.
371 tristate "Driver for Rockchip Ethernet PHYs"
373 Currently supports the integrated Ethernet PHY.
378 Currently supports the LAN83C185, LAN8187 and LAN8700 PHYs
381 tristate "STMicroelectronics STe10Xp PHYs"
383 This is the driver for the STe100p and STe101p PHYs.
385 config TERANETICS_PHY
386 tristate "Teranetics PHYs"
388 Currently supports the Teranetics TN2020
391 tristate "Vitesse PHYs"
393 Currently supports the vsc8244
395 config XILINX_GMII2RGMII
396 tristate "Xilinx GMII2RGMII converter driver"
398 This driver support xilinx GMII to RGMII IP core it provides
399 the Reduced Gigabit Media Independent Interface(RGMII) between
400 Ethernet physical media devices and the Gigabit Ethernet controller.
404 config MICREL_KS8995MA
405 tristate "Micrel KS8995MA 5-ports 10/100 managed Ethernet switch"