arch/arm64/boot/dts/qcom/pm8916.dtsi

   1 // SPDX-License-Identifier: GPL-2.0
   2 #include <dt-bindings/iio/qcom,spmi-vadc.h>
   3 #include <dt-bindings/input/linux-event-codes.h>
   4 #include <dt-bindings/interrupt-controller/irq.h>
   5 #include <dt-bindings/spmi/spmi.h>
   6
   7 &spmi_bus {
   8
   9         pm8916_0: pmic@0 {
  10                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
  11                 reg = <0x0 SPMI_USID>;
  12                 #address-cells = <1>;
  13                 #size-cells = <0>;
  14
  15                 pon@800 {
  16                         compatible = "qcom,pm8916-pon";
  17                         reg = <0x800>;
  18                         mode-bootloader = <0x2>;
  19                         mode-recovery = <0x1>;
  20
  21                         pwrkey {
  22                                 compatible = "qcom,pm8941-pwrkey";
  23                                 interrupts = <0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
  24                                 debounce = <15625>;
  25                                 bias-pull-up;
  26                                 linux,code = <KEY_POWER>;
  27                         };
  28
  29                         pm8916_resin: resin {
  30                                 compatible = "qcom,pm8941-resin";
  31                                 interrupts = <0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
  32                                 debounce = <15625>;
  33                                 bias-pull-up;
  34                                 status = "disabled";
  35                         };
  36
  37                         watchdog {
  38                                 compatible = "qcom,pm8916-wdt";
  39                                 interrupts = <0x0 0x8 6 IRQ_TYPE_EDGE_RISING>;
  40                                 timeout-sec = <60>;
  41                         };
  42                 };
  43
  44                 pm8916_usbin: usb-detect@1300 {
  45                         compatible = "qcom,pm8941-misc";
  46                         reg = <0x1300>;
  47                         interrupts = <0x0 0x13 1 IRQ_TYPE_EDGE_BOTH>;
  48                         interrupt-names = "usb_vbus";
  49                         status = "disabled";
  50                 };
  51
  52                 pm8916_temp: temp-alarm@2400 {
  53                         compatible = "qcom,spmi-temp-alarm";
  54                         reg = <0x2400>;
  55                         interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
  56                         io-channels = <&pm8916_vadc VADC_DIE_TEMP>;
  57                         io-channel-names = "thermal";
  58                         #thermal-sensor-cells = <0>;
  59                 };
  60
  61                 pm8916_vadc: adc@3100 {
  62                         compatible = "qcom,spmi-vadc";
  63                         reg = <0x3100>;
  64                         interrupts = <0x0 0x31 0x0 IRQ_TYPE_EDGE_RISING>;
  65                         #address-cells = <1>;
  66                         #size-cells = <0>;
  67                         #io-channel-cells = <1>;
  68
  69                         channel@0 {
  70                                 reg = <VADC_USBIN>;
  71                                 qcom,pre-scaling = <1 10>;
  72                         };
  73                         channel@7 {
  74                                 reg = <VADC_VSYS>;
  75                                 qcom,pre-scaling = <1 3>;
  76                         };
  77                         channel@8 {
  78                                 reg = <VADC_DIE_TEMP>;
  79                         };
  80                         channel@9 {
  81                                 reg = <VADC_REF_625MV>;
  82                         };
  83                         channel@a {
  84                                 reg = <VADC_REF_1250MV>;
  85                         };
  86                         channel@e {
  87                                 reg = <VADC_GND_REF>;
  88                         };
  89                         channel@f {
  90                                 reg = <VADC_VDD_VADC>;
  91                         };
  92                 };
  93
  94                 rtc@6000 {
  95                         compatible = "qcom,pm8941-rtc";
  96                         reg = <0x6000>, <0x6100>;
  97                         reg-names = "rtc", "alarm";
  98                         interrupts = <0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
  99                 };
 100
 101                 pm8916_mpps: mpps@a000 {
 102                         compatible = "qcom,pm8916-mpp", "qcom,spmi-mpp";
 103                         reg = <0xa000>;
 104                         gpio-controller;
 105                         #gpio-cells = <2>;
 106                         gpio-ranges = <&pm8916_mpps 0 0 4>;
 107                         interrupt-controller;
 108                         #interrupt-cells = <2>;
 109                 };
 110
 111                 pm8916_gpios: gpio@c000 {
 112                         compatible = "qcom,pm8916-gpio", "qcom,spmi-gpio";
 113                         reg = <0xc000>;
 114                         gpio-controller;
 115                         gpio-ranges = <&pm8916_gpios 0 0 4>;
 116                         #gpio-cells = <2>;
 117                         interrupt-controller;
 118                         #interrupt-cells = <2>;
 119                 };
 120         };
 121
 122         pm8916_1: pmic@1 {
 123                 compatible = "qcom,pm8916", "qcom,spmi-pmic";
 124                 reg = <0x1 SPMI_USID>;
 125                 #address-cells = <1>;
 126                 #size-cells = <0>;
 127
 128                 pm8916_pwm: pwm {
 129                         compatible = "qcom,pm8916-pwm";
 130
 131                         #pwm-cells = <2>;
 132
 133                         status = "disabled";
 134                 };
 135
 136                 pm8916_vib: vibrator@c000 {
 137                         compatible = "qcom,pm8916-vib";
 138                         reg = <0xc000>;
 139                         status = "disabled";
 140                 };
 141
 142                 pm8916_codec: audio-codec@f000 {
 143                         compatible = "qcom,pm8916-wcd-analog-codec";
 144                         reg = <0xf000>;
 145                         interrupt-parent = <&spmi_bus>;
 146                         interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
 147                                      <0x1 0xf0 0x1 IRQ_TYPE_NONE>,
 148                                      <0x1 0xf0 0x2 IRQ_TYPE_NONE>,
 149                                      <0x1 0xf0 0x3 IRQ_TYPE_NONE>,
 150                                      <0x1 0xf0 0x4 IRQ_TYPE_NONE>,
 151                                      <0x1 0xf0 0x5 IRQ_TYPE_NONE>,
 152                                      <0x1 0xf0 0x6 IRQ_TYPE_NONE>,
 153                                      <0x1 0xf0 0x7 IRQ_TYPE_NONE>,
 154                                      <0x1 0xf1 0x0 IRQ_TYPE_NONE>,
 155                                      <0x1 0xf1 0x1 IRQ_TYPE_NONE>,
 156                                      <0x1 0xf1 0x2 IRQ_TYPE_NONE>,
 157                                      <0x1 0xf1 0x3 IRQ_TYPE_NONE>,
 158                                      <0x1 0xf1 0x4 IRQ_TYPE_NONE>,
 159                                      <0x1 0xf1 0x5 IRQ_TYPE_NONE>;
 160                         interrupt-names = "cdc_spk_cnp_int",
 161                                           "cdc_spk_clip_int",
 162                                           "cdc_spk_ocp_int",
 163                                           "mbhc_ins_rem_det1",
 164                                           "mbhc_but_rel_det",
 165                                           "mbhc_but_press_det",
 166                                           "mbhc_ins_rem_det",
 167                                           "mbhc_switch_int",
 168                                           "cdc_ear_ocp_int",
 169                                           "cdc_hphr_ocp_int",
 170                                           "cdc_hphl_ocp_det",
 171                                           "cdc_ear_cnp_int",
 172                                           "cdc_hphr_cnp_int",
 173                                           "cdc_hphl_cnp_int";
 174                         #sound-dai-cells = <1>;
 175                         status = "disabled";
 176                 };
 177         };
 178 };