arch/arm64/boot/dts/qcom/pm2250.dtsi

   1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
   2 /*
   3  * Copyright (c) 2023, Linaro Ltd
   4  */
   5
   6 #include <dt-bindings/iio/qcom,spmi-vadc.h>
   7 #include <dt-bindings/input/input.h>
   8 #include <dt-bindings/interrupt-controller/irq.h>
   9 #include <dt-bindings/spmi/spmi.h>
  10
  11 &spmi_bus {
  12         pmic@0 {
  13                 compatible = "qcom,pm2250", "qcom,spmi-pmic";
  14                 reg = <0x0 SPMI_USID>;
  15                 #address-cells = <1>;
  16                 #size-cells = <0>;
  17
  18                 pon@800 {
  19                         compatible = "qcom,pm8916-pon";
  20                         reg = <0x800>;
  21
  22                         pm2250_pwrkey: pwrkey {
  23                                 compatible = "qcom,pm8941-pwrkey";
  24                                 interrupts-extended = <&spmi_bus 0x0 0x8 0 IRQ_TYPE_EDGE_BOTH>;
  25                                 linux,code = <KEY_POWER>;
  26                                 debounce = <15625>;
  27                                 bias-pull-up;
  28                         };
  29
  30                         pm2250_resin: resin {
  31                                 compatible = "qcom,pm8941-resin";
  32                                 interrupts-extended = <&spmi_bus 0x0 0x8 1 IRQ_TYPE_EDGE_BOTH>;
  33                                 debounce = <15625>;
  34                                 bias-pull-up;
  35                                 status = "disabled";
  36                         };
  37                 };
  38
  39                 rtc@6000 {
  40                         compatible = "qcom,pm8941-rtc";
  41                         reg = <0x6000>, <0x6100>;
  42                         reg-names = "rtc", "alarm";
  43                         interrupts-extended = <&spmi_bus 0x0 0x61 0x1 IRQ_TYPE_EDGE_RISING>;
  44                 };
  45
  46                 pm2250_gpios: gpio@c000 {
  47                         compatible = "qcom,pm2250-gpio", "qcom,spmi-gpio";
  48                         reg = <0xc000>;
  49                         gpio-controller;
  50                         gpio-ranges = <&pm2250_gpios 0 0 10>;
  51                         #gpio-cells = <2>;
  52                         interrupt-controller;
  53                         #interrupt-cells = <2>;
  54                 };
  55         };
  56
  57         pmic@1 {
  58                 compatible = "qcom,pm2250", "qcom,spmi-pmic";
  59                 reg = <0x1 SPMI_USID>;
  60                 #address-cells = <1>;
  61                 #size-cells = <0>;
  62         };
  63 };