1 * Marvell Armada 370 / Armada XP Ethernet Controller (NETA)
4 - compatible: "marvell,armada-370-neta" or "marvell,armada-xp-neta".
5 - reg: address and length of the register set for the device.
6 - interrupts: interrupt for the device
7 - phy: See ethernet.txt file in the same directory.
8 - phy-mode: See ethernet.txt file in the same directory
9 - clocks: List of clocks for this device. At least one clock is
10 mandatory for the core clock. If several clocks are given, then the
11 clock-names property must be used to identify them.
14 - tx-csum-limit: maximum mtu supported by port that allow TX checksum.
15 Value is presented in bytes. If not used, by default 1600B is set for
16 "marvell,armada-370-neta" and 9800B for others.
17 - clock-names: List of names corresponding to clocks property; shall be
18 "core" for core clock and "bus" for the optional bus clock.
21 Optional properties (valid only for Armada XP/38x):
23 - buffer-manager: a phandle to a buffer manager node. Please refer to
24 Documentation/devicetree/bindings/net/marvell-neta-bm.txt
25 - bm,pool-long: ID of a pool, that will accept all packets of a size
26 higher than 'short' pool's threshold (if set) and up to MTU value.
27 Obligatory, when the port is supposed to use hardware
29 - bm,pool-short: ID of a pool, that will be used for accepting
30 packets of a size lower than given threshold. If not set, the port
31 will use a single 'long' pool for all packets, as defined above.
36 compatible = "marvell,armada-370-neta";
37 reg = <0x70000 0x2500>;
39 clocks = <&gate_clk 4>;
40 tx-csum-limit = <9800>
43 phy-mode = "rgmii-id";
44 buffer-manager = <&bm>;