Documentation/devicetree/bindings/net/can/tcan4x5x.txt

   1 Texas Instruments TCAN4x5x CAN Controller
   2 ================================================
   3
   4 This file provides device node information for the TCAN4x5x interface contains.
   5
   6 Required properties:
   7         - compatible:
   8                 "ti,tcan4552", "ti,tcan4x5x"
   9                 "ti,tcan4553", "ti,tcan4x5x" or
  10                 "ti,tcan4x5x"
  11         - reg: 0
  12         - #address-cells: 1
  13         - #size-cells: 0
  14         - spi-max-frequency: Maximum frequency of the SPI bus the chip can
  15                              operate at should be less than or equal to 18 MHz.
  16         - interrupt-parent: the phandle to the interrupt controller which provides
  17                     the interrupt.
  18         - interrupts: interrupt specification for data-ready.
  19
  20 See Documentation/devicetree/bindings/net/can/bosch,m_can.yaml for additional
  21 required property details.
  22
  23 Optional properties:
  24         - reset-gpios: Hardwired output GPIO. If not defined then software
  25                        reset.
  26         - device-state-gpios: Input GPIO that indicates if the device is in
  27                               a sleep state or if the device is active. Not
  28                               available with tcan4552/4553.
  29         - device-wake-gpios: Wake up GPIO to wake up the TCAN device. Not
  30                              available with tcan4552/4553.
  31
  32 Example:
  33 tcan4x5x: tcan4x5x@0 {
  34                 compatible = "ti,tcan4x5x";
  35                 reg = <0>;
  36                 #address-cells = <1>;
  37                 #size-cells = <1>;
  38                 spi-max-frequency = <10000000>;
  39                 bosch,mram-cfg = <0x0 0 0 16 0 0 1 1>;
  40                 interrupt-parent = <&gpio1>;
  41                 interrupts = <14 IRQ_TYPE_LEVEL_LOW>;
  42                 device-state-gpios = <&gpio3 21 GPIO_ACTIVE_HIGH>;
  43                 device-wake-gpios = <&gpio1 15 GPIO_ACTIVE_HIGH>;
  44                 reset-gpios = <&gpio1 27 GPIO_ACTIVE_HIGH>;
  45 };