1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
4 $id: http://devicetree.org/schemas/gpio/gpio-mmio.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Generic MMIO GPIO
10 - Linus Walleij <linus.walleij@linaro.org>
11 - Bartosz Golaszewski <brgl@bgdev.pl>
14 Some simple GPIO controllers may consist of a single data register or a pair
15 of set/clear-bit registers. Such controllers are common for glue logic in
16 FPGAs or ASICs. Commonly, these controllers are accessed over memory-mapped
17 NAND-style parallel busses.
24 - wd,mbl-gpio # Western Digital MyBook Live memory-mapped GPIO controller
38 A list of registers in the controller. The width of each register is
39 determined by its size. All registers must have the same width. The number
40 of GPIOs is set by the width, with bit 0 corresponding to GPIO 0.
43 Register to READ the value of the GPIO lines. If GPIO line is high,
44 the bit will be set. If the GPIO line is low, the bit will be cleared.
45 This register may also be used to drive GPIOs if the SET register is
48 Register to SET the value of the GPIO lines. Setting a bit in this
49 register will drive the GPIO line high.
51 Register to CLEAR the value of the GPIO lines. Setting a bit in this
52 register will drive the GPIO line low. If this register is omitted,
53 the SET register will be used to clear the GPIO lines as well, by
54 actively writing the line with 0.
56 Register to set the line as OUTPUT. Setting a bit in this register
57 will turn that line into an output line. Conversely, clearing a bit
58 will turn that line into an input.
60 Register to set this line as INPUT. Setting a bit in this register
61 will turn that line into an input line. Conversely, clearing a bit
62 will turn that line into an output.
78 $ref: /schemas/types.yaml#/definitions/flag
80 If this property is present, the controller cannot drive the GPIO lines.
89 additionalProperties: false
94 compatible = "ni,169445-nand-gpio";
95 reg = <0x1f300010 0x4>;
102 compatible = "wd,mbl-gpio";
104 reg = <0xe0100000 0x1>;
111 compatible = "brcm,bcm6345-gpio";
112 reg-names = "dirout", "dat";
113 reg = <0xfffe0406 2>, <0xfffe040a 2>;