1 * MAX732x-compatible I/O expanders
4 - compatible: Should be one of the following:
5 - "maxim,max7319": For the Maxim MAX7319
6 - "maxim,max7320": For the Maxim MAX7320
7 - "maxim,max7321": For the Maxim MAX7321
8 - "maxim,max7322": For the Maxim MAX7322
9 - "maxim,max7323": For the Maxim MAX7323
10 - "maxim,max7324": For the Maxim MAX7324
11 - "maxim,max7325": For the Maxim MAX7325
12 - "maxim,max7326": For the Maxim MAX7326
13 - "maxim,max7327": For the Maxim MAX7327
14 - reg: I2C slave address for this device.
15 - gpio-controller: Marks the device node as a GPIO controller.
16 - #gpio-cells: Should be 2.
17 - first cell is the GPIO number
18 - second cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>.
19 Only the GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported.
23 The I/O expander can detect input state changes, and thus optionally act as
24 an interrupt controller. When the expander interrupt line is connected all the
25 following properties must be set. For more information please see the
26 interrupt controller device tree bindings documentation available at
27 Documentation/devicetree/bindings/interrupt-controller/interrupts.txt.
29 - interrupt-controller: Identifies the node as an interrupt controller.
30 - #interrupt-cells: Number of cells to encode an interrupt source, shall be 2.
31 - first cell is the pin number
32 - second cell is used to specify flags
33 - interrupt-parent: phandle of the parent interrupt controller.
34 - interrupts: Interrupt specifier for the controllers interrupt.
36 Please refer to gpio.txt in this directory for details of the common GPIO
37 bindings used by client devices.
39 Example 1. MAX7325 with interrupt support enabled (CONFIG_GPIO_MAX732X_IRQ=y):
41 expander: max7325@6d {
42 compatible = "maxim,max7325";
47 #interrupt-cells = <2>;
48 interrupt-parent = <&gpio4>;
49 interrupts = <29 IRQ_TYPE_EDGE_FALLING>;
52 Example 2. MAX7325 with interrupt support disabled (CONFIG_GPIO_MAX732X_IRQ=n):
54 expander: max7325@6d {
55 compatible = "maxim,max7325";