1 Allwinner A31 DSI Encoder
2 =========================
4 The DSI pipeline consists of two separate blocks: the DSI controller
5 itself, and its associated D-PHY.
10 The DSI Encoder generates the DSI signal from the TCON's.
13 - compatible: value must be one of:
14 * allwinner,sun6i-a31-mipi-dsi
15 - reg: base address and size of memory-mapped region
16 - interrupts: interrupt associated to this IP
17 - clocks: phandles to the clocks feeding the DSI encoder
18 * bus: the DSI interface clock
19 * mod: the DSI module clock
20 - clock-names: the clock names mentioned above
21 - phys: phandle to the D-PHY
22 - phy-names: must be "dphy"
23 - resets: phandle to the reset controller driving the encoder
25 - ports: A ports node with endpoint definitions as defined in
26 Documentation/devicetree/bindings/media/video-interfaces.txt. The
27 first port should be the input endpoint, usually coming from the
30 Any MIPI-DSI device attached to this should be described according to
31 the bindings defined in ../mipi-dsi-bus.txt
37 - compatible: value must be one of:
38 * allwinner,sun6i-a31-mipi-dphy
39 - reg: base address and size of memory-mapped region
40 - clocks: phandles to the clocks feeding the DSI encoder
41 * bus: the DSI interface clock
42 * mod: the DSI module clock
43 - clock-names: the clock names mentioned above
44 - resets: phandle to the reset controller driving the encoder
49 compatible = "allwinner,sun6i-a31-mipi-dsi";
50 reg = <0x01ca0000 0x1000>;
51 interrupts = <GIC_SPI 89 IRQ_TYPE_LEVEL_HIGH>;
52 clocks = <&ccu CLK_BUS_MIPI_DSI>,
54 clock-names = "bus", "mod";
55 resets = <&ccu RST_BUS_MIPI_DSI>;
62 compatible = "bananapi,lhr050h41", "ilitek,ili9881c";
64 power-gpios = <&pio 1 7 GPIO_ACTIVE_HIGH>; /* PB07 */
65 reset-gpios = <&r_pio 0 5 GPIO_ACTIVE_LOW>; /* PL05 */
66 backlight = <&pwm_bl>;
78 dsi0_in_tcon0: endpoint {
79 remote-endpoint = <&tcon0_out_dsi0>;
85 dphy0: d-phy@1ca1000 {
86 compatible = "allwinner,sun6i-a31-mipi-dphy";
87 reg = <0x01ca1000 0x1000>;
88 clocks = <&ccu CLK_BUS_MIPI_DSI>,
90 clock-names = "bus", "mod";
91 resets = <&ccu RST_BUS_MIPI_DSI>;